Anycubic Vyper Tool Drawer by Marksman702

After buying an Un-repaired Anycubic Vyper it arrived with a missing Tool drawer and because you cannot buy one of these anymore I decided to make one and share it. I have tried my first example and the magnets work and hold the drawer perfectly, one thing to say though is that the magnets may need reversing on some Vyper models, which I have just found out as the polarity on the inside of the unit caused the drawer to push back out but once I turned them around, they are good. Support is only required for the pull knob, however I am looking at changing this so that supports are not required, ideas welcome from you budding designers :) Enjoy

Download from thingiverse