8BitDo SN30 Pro Case remix with covered sticks by KArlka

Remix of the "8BitDo SN30 Pro Case" by "thehair". Thanks for the nice case! I only covered the sticks for extra protection so they would not rub on anything while traveling. To put the case on, first fit the top part, where the charging port is and then press down on the bottom part. If you try the other way around, the sticks will be in the way. To remove it, push the case at the bottom away from the controller. I printed it upright with treesupports on the baseplate only, probably could get away without any supports. I used a Brim so it would stick to the bed. My print has some artefacts on the front, maybe cura is to blame for that.

Download from thingiverse