LED Controller - 4 Channel by tazinaz87

LED Controller

4 Channel LED controller for addressable LEDs in a water resistant case.

There are 4 STL files:
Box
Lid
Lid Gasket
USB Grommet Cover

The Build_Doc PDF provides a listing of all the parts used in the build, as well as a schematic and photos of how the board is laid out.

Depending on your application - any material should be fine to use. If using outdoors (and in sunlight) would recommend using a material better suited for outdoors (ASA/ABS).

All of the parts are printed w/o the need for supports. Brims can be helpful when using materials that are prone to warping like ABS.

The Lid gasket was printed using TPU and is optional (if you are using indoors). Silicone or other sealant can be used in place of the gasket if using outdoors.

The USB Grommet was also printed using TPU and is optional. If printed with a more rigid plastic, it may need to be scaled down to correctly fit the USB opening in the box.

Programming of the controller uses WLED and the URL is listed in the instruction PDF.

Inspired by videos posted by ResinChem Tech